Switching On The Printer And Printing Of Self-Test; Switching On The Printer; Printing A Self-Test Page; Setting Of Printer Parameters And Configuration - SNBC BTP-R580 User Manual

Table of Contents

paper roll cores can be accommodated and also the remaining paper-end length can be

approximated.

Caution:

The factory setting of the paper near end sensor is level 1.

1) When using different Diameter core shaft, C diameter may be different with the length of the

remaining paper at the same level.

4.8 Switching on the printer and printing of self-test

Ensure that the printer is connected to the mains voltage and, if applicable, that the mains

voltage is switched on.

Switch on the power of the printer.

1) Confirm that the printer is connected to the mains voltage and that a paper roll is in the

printer.

2) Confirm that the printer is switched off.

3) Press down the FEED button while switching on the printer, the printer will start printing the

configuration sheet. At the end of the configuration sheet the followings text will appear:

"Press feed key to continue" The printer is holding and waiting for the input while the PAPER

LED is flashing.

4) Press down the FEED button shortly, the printer will print a character test page which is part

of the self-test.

The parameters of the printer can be set (configuring) in a detailed way by means of the utility

software that is available from the reseller or from SNBC by special request.

- 13 -

BTP-R580 User's Manual

Table of Contents

Show Quick Links

Table of Contents