Appendix 2 Eeprom Setting Table - SNBC BK-T6112 Service Manual

Appendix 2 EEPROM setting table

EEPROM Address
(HEX)
02
06
12
3C
3E
33
25
24
4a
26
36
Notes:
Please use command "1B 73 42 45 92 9A DL DH AD" to change EEPROM setting of the printer". 1B
73 42 45 92 9A" is the fixed format of the command, "DL DH" is the data to be written into, with low
byte in the beginning; "AD" is the EEPROM address (please refer to EEPROM setting). For instance,
send command "1B 73 42 45 92 9A 00 00 12" to the printer, then the paper type will be changed into
continuous paper.
Power on the printer again after changing the EEPROM setting to make the change valid.
Function
Print darkness
1-side print speed (Max.)
Paper type
PRESENTER waiting time
PRESENTER enabled
Print influence of paper near
end status
Default right margin
Default left margin
PRESENTER paper
mode
Paper width
Default code page
international character set
Two print heads: [range] 1-254，1-254
50-350
0: Continuous paper; 1: Marked paper
[range] 0-240; Unit: s
High byte: 0~254; Low byte: 0~254.
High byte: Automatic identification of paper out module enabled;
Low byte: Presenter enabled, and valid when the high byte is 0.
0: no influence;1: If paper is near end before printing, it will wait.
Unit: mm, Default value: 2
Unit: mm, Default value: 2
Low byte:
out
0: retract paper; 1: eject paper; 2: hold paper; 3: eject paper;
4: throw out paper
79.5-112, unit: mm
Low byte: default CodePage
0: PC437 1: Katakana 2: PC850 3: PC860
and
4: PC863 5: PC865 18: PC852 19: PC858
17: PC866 16: WPC1252
High byte: default international character set
- 35 -
BK-T6112 Service Manual
Range & Description