Table of Contents
Advertisement
Appendix 2.4.
Module Error Code (o_ud16 ModuleErrId) list
Some FBs in this FB library return an error code to Module Error Code (o_u16ModuleErrId) when a module error occurs
(with o_uErrId being a hexadecimal value of "FFFF"). Module error codes that may be output are listed below.
Error Code
Hexadecimal
(Decimal)
64
A command not included in the command list was
(100)
received.
65
A setting parameter outside the valid range was
(101)
received.
66
Write was requested with settings not supported by
(102)
the target controller.
190
Calibration was attempted with no alarm specified
(400)
or the display range exceeded.
191
Calibration was not correctly performed.
(401)
1F4
Teaching was attempted with no alarm specified or
(500)
the display range exceeded.
1F5
Teaching was not performed.
(501)
258
Presetting was attempted with no alarm specified or
(600)
the display range exceeded.
2BC
Bank loading or saving was attempted with the bank
(700)
number outside the valid range.
320
Failed to write to EEPROM.
(800)
384
Controller did not respond within 100 ms of a
(900)
command request.
Description
SC-HG1 Series FB Library Reference Manual for Mitsubishi MELSEC iQ-R series Sequencer
Enter the correct command.
Enter a valid parameter.
Enter a valid parameter.
The head value is invalid. Check the head status.
Calibration failed.
For information on the calibration procedure, refer to
"Contact-Type Digital Displacement Sensor HG-S
Series User's Manual ".
The head value is invalid. Check the head status.
Teaching failed.
For information on the teaching procedure, refer to
"Contact-Type Digital Displacement Sensor HG-S
Series User's Manual ".
The head value is invalid. Check the head status.
Enter a valid parameter.
The controller may be faulty.
Check the controller status.
Check the controller connection status. Check for
faulty controllers.
159/184
Meaning
WUME-SCHG1IQRFB-1
Advertisement
Table of Contents
