Programming Controllers/Transmitters; Programming Features - Excalibur AL-2060-EDPB Operation Manual

Standard Programming: Use this method to program additional or replacement
transmitters� Before you begin, have all transmitters at hand and make sure the cor-
rect vehicle profile (see page 12) is selected on the controller(s).
Step 1 Then, turn the ignition "on"�
Step 2 Within 5 seconds of Step 1, press the Valet Switch 5 times� The siren/horn will
briefly sound, confirming that the system is ready to learn a transmitter code.
Step 3 Press the "lock" button on each transmitter one at a time� The system will
chirp the siren/horn once to confirm that each was learned. If a code is not received
within 10 seconds of Step 2, the learning process will automatically exit.
Step 1 Turn the ignition key "ON", then "OFF"�
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user
features (10 times to access installer features)�
~ The siren/horn will sound and the status light will turn on�
Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-
responding with the desired feature's number�
~ The siren/horn will chirp, the status lights, and the parking lights will flash equal
to the selected feature�
Step 4 Change the feature by pressing the transmitter button that corresponds with
the desired setting� The siren/horn will chirp to correspond with the chosen setting�

Programming Controllers/Transmitters

Programming Features

19