Programming Controllers/Transmitters; Programming Features - Excalibur AL-1830-EDPB Operation Manual

Deluxe 2-way alarm & remote start

Hide thumbs

Table Of Contents

Table of Contents

Standard Programming: Using this method to program additional or replace-

ment transmitters does not turn on or otherwise affect the Unauthorized Transmitter

Alert (UTA) feature. Before you begin, have all transmitters which are to operate the

system at hand and make sure the correct vehicle profile (see page 12) is selected on

the controller(s)

Step 1 Then, turn the ignition "on"

Step 2 Within 5 seconds of Step 1, press the Valet Switch 5 times. The siren/horn will

briefly sound, confirming that the system is ready to learn a transmitter code.

Step 3 Press the "lock" button on each transmitter one at a time The system will

chirp the siren/horn once to confirm that each was learned. If a code is not received

within 10 seconds of Step 2, the learning process will automatically exit.

If the Unauthorized Transmitter Alert feature is on, programming a transmitter to the

system will activate the "UTA" warning and the extended Status Light indication For

the next 48 hours, the siren/horn will sound a brief series of chirps every time the

vehicle's ignition key is turned on

Special Programming procedure to turn on the UTA feature: Using this method

to program transmitters or optional controllers, and to turn on the Unauthorized Trans-

mitter Alert feature.

Follow the same steps as the Standard Programming, but on any transmitter/con-

troller being programmed instead of pressing the "lock" button, press the "lock" and

the "unlock" buttons together This action turns on the Unauthorized Transmitter

Alert feature and at the same time programs the transmitter or controller to operate

the system

Once the Unauthorized Transmitter Alert feature is turned on, the warning will

sound for 48 hours after any transmitter programming, including the programming

session which was used to turn it on. This feature can only be turned off again by

sending the system back to Omega for a reset.

Step 1 Turn the ignition key "On", then "OFF"

Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user

features (10 times to access installer features).

~ The siren/horn will sound and the status light will turn on

Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-

responding with the desired feature's number.

~ The siren/horn will chirp, the status lights, and the parking lights will flash equal

to the selected feature.

Step 4 Change the feature by pressing the transmitter button that corresponds with

the desired setting The siren/horn will chirp to correspond with the chosen setting