THE CONTROLLER LOCK button UNLOCK button START button TRUNK button System Controller(s) Battery AL-1670-B 1415-03 (x2) CR-2016 (2 per controller) RS-375-3DB 1412-03 (x2) CR-2032 (1 per controller) RS-370-3D 1412-03 (x2) CR-2032 (2 per controller) RS-370 1415-03 1416-07 CR-2016 (x2) CR-2032 (x1)
Page 4
Controller Functions (cont’d) UNLOCK / DISARM: Press and release the UNLOCK button� • THE SIREN WILL CHIRP TWICE & THE PARKING LIGHTS WILL FLASH TWICE� TRUNK RELEASE / CHANNEL 2: Press the TRUNK button for 3 seconds� • THE SYSTEM WILL UNLOCK/DISARM AND THE TRUNK WILL OPEN (IF EQUIPPED)�...
Page 5
Controller Functions (cont’d) • Run Time Extender: Press the START button one time during remote start to restart the engine run timer� The timer will restart� NOTE: This can only be used once per remote start cycle. • If you decide not to drive your vehicle, you can turn off the remote start using the same method to turn it on (Default = press START twice in 5 seconds)�...
Page 6
Controller Functions (cont’d) PANIC: Press and hold the LOCK or UNLOCK button for 3 seconds� • THE SIREN/HORN WILL SOUND, THE PARKING LIGHTS WILL FLASH, AND THE DOORS WILL LOCK OR UNLOCK DEPENDING WHICH BUTTON IS PRESSED� SILENT ARM / DISARM: Press and release the TRUNK button twice in 5 seconds�...
Page 7
Controller Functions (cont’d) AUXILIARY FUNCTIONS 1-4: The actual operation of these functions will vary from car to car� They are designed to operate extra vehicle functions like automatic sliding doors or motorized hatches� Aux 1-4 are virtual outputs only available on certain vehicles when this system is integrated with the vehicle’s data network.
Other Remote Start Features LOW BATTERY/LOW TEMP AUTOMATIC STARTING This feature will automatically start the engine if the vehicle battery drops below 11 volts or the interior temperature drops to 15 (or 32) degrees fahrenheit� You must activate these features each time you park your car to use them� Method 1 - Valet Switch •...
Other Remote Start Features (cont’d) MANUAL TRANSMISSION STARTING Remote starting with a manual transmission requires that you ensure the gear selector is in NEUTRAL� There are 2 available methods� METHOD #1 - 3D MOTION SENSOR: Some models are equipped with a 3D motion sensor built into the antenna (optional sensors are available as an upgrade)�...
Security System Features (cont’d) WHEN THE SYSTEM TRIGGERS It will sound the siren/horn and flash the parking lights for 30 seconds (programmable). When disarming after a trigger event, the siren/horn will chirp 4 times and the parking lights will flash 4 times instead of the standard 2 times. LOCK ON TRIGGER: If a door is opened when the system is triggered, it will wait until the door is closed again, then lock the doors�...
Using The Valet Button (cont’d) VALET MODE Valet mode completely disables all security & remote start functions� Keyless entry is still operable� To enter valet mode, perform the following steps: STEP 1 - Disarm the system by remote or by performing an emergency override� STEP 2 - Press and hold the valet switch for 2 seconds�...
Anti-Carjacking Protection The system is equipped with two separate Anti-Carjacking protection features (ignition, open door, or both)� All are programmable, and must be turned on to operate� Once activated, the user has 60 seconds to cancel the Anti-Carjacking protection process (described below)�...
Programming Controllers/Transmitters Standard Programming: Using this method to program additional or replacement transmitters does not turn on or otherwise affect the Unauthorized Transmitter Alert (UTA) feature� Before you begin, have all transmitters which are to operate the system at hand� Step 1 Then, turn the ignition “on”�...
User Programmable Features Feature #1 - Remote Start Run Time 3 Minutes (press LOCK to program) 10 Minutes (press UNLOCK to program) 15 Minutes (press TRUNK to program) 20 Minutes (press START to program) 30 Minutes (press LOCK & UNLOCK to program) This sets the maximum amount of time that the remote start will keep the engine running if it is not shut down by other methods�...
Page 15
User Programmable Features (cont’d) Feature #7 - Unlock w/ Trunk Release (press LOCK to program) (press UNLOCK to program) “2nd channel” is most commonly used for trunk release, in which case the alarm should also disarm. This feature, when on, configures the system to unlock/disarm when the 2nd channel is activated�...
Page 16
User Programmable Features (cont’d) Feature #13 - SecureCode DEFAULT - 1 Press SecureCode is a unique patented feature which allows you to select the number of Valet Switch presses in two stages, instead of “1 press”, which would be required in order to perform an Emergency Override�...
Installer Programmable Features This group of Installer Programmable Features are all accessed as a group in the second level of features’ programming� These features have a direct affect upon the system’s op- erations related to the installation and vehicle type AND SHOULD ONLY BE CHANGED BY THE INSTALLER!!! Feature #1 - Remote Start Activation From The WHITE/BLUE Wire 1 pulse...
Page 20
Installer Programmable Features (cont’d) Feature #5 - Light Relay Function Dome Light Output (press LOCK to program) Start (press UNLOCK to program) Ignition Output (press TRUNK to program) Accessory Output (press START to program) Status (press LOCK & UNLOCK to program) Light Flash (press TRUNK &...
Page 21
Installer Programmable Features (cont’d) Feature #10 - Turbo Timer (press LOCK to program) Run 1 Minute (press UNLOCK to program) Run 2 Minutes (press TRUNK to program) Run 3 Minutes (press START to program) This feature, the operation of which is described on page 8, when turned on configures the system to automatically keep the engine running briefly after the key is turned off.
Page 22
Installer Programmable Features (cont’d) Feature #17 Low Temp Crank Extender (press LOCK to program) 200ms (press UNLOCK to program) 300ms (press TRUNK to program) 400ms (press START to program) When the vehicle’s interior temperature is below freezing, this feature adds extra crank time to the base timing (see installer feature #7)�...
Page 23
User Feature Programming: Ignition on, off, press valet 5 times Lock + Trunk Lock Button Unlock button Trunk button Start button # Feature Unlock + Start (Brake 1x) (Brake 2x) (Brake 3x) (Brake 4x) (Brake 5x) (Brake 6x) 1 Remote Start Run Time 3 min 10 min 15 min...
Page 24
Back Cover Color cover is in a separate file.