Excalibur AL-2060-EDPB Operation Manual page 24

Installer Programmable Features (cont'd)
Feature #5 - Light Relay Function
Dome Light Output
Start
Ignition Output
Accessory Output
Status
The system has two built-in relays, which can be programmed to perform several different func-
tions� The primary function of this relay, is to operate the vehicle's dome, or interior lighting as
part of the system's operations� Optionally, if desired or needed, this relay can be programmed for
the other functions listed above�
Feature #6 Blue Satellite Port, Blue Wire Function
Ignition
Status / GWR
Defrost Pulse
Pulse After Engine Off
Horn
This determines the function of the Blue wire on the Blue satellite relay port�
The Status setting turns on briefly before the Ignition output and stays on during remote start
mode� The other pulse settings give a 0�8 second pulse under the selected condition� Defrost
Pulse will send a pulse after start only when the cabin temperature is below freezing (32 degrees
F / 0 degrees C)�
Feature #7 - Starter Cranking Time
0.75 Second (press "lock" button to program) - DEFAULT
1.00 Second (press "unlock" button to program)
1.5 Seconds (press "trunk" button to program)
2.25 Seconds (press "start" button to program)
This feature determines the crank time of the 1st start attempt when in "Tachless" mode� If the
engine doesn't start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 0�2 second with each attempt��
Feature #8 - Door Lock/Unlock Outputs
0.8 Second Outputs
3 Second Outputs
Double Pulse Unlock Output (press "trunk" button to program)
Total Closure Lock Output
This changes the system's doorlocking outputs to suite different vehicle requirements� The total
closure setting provides a 28 second lock pulse (press LOCK or UNLOCK is during the pulse to
stop it) and a 0�8 second unlock pulse�
Feature #9 Remote Start Lock Control
Off
Lock After Start
Unlock before start
Unlock Before RS & Lock After RS
This feature allows for OEM alarm/lock control in relation to remote start operations thus eliminat-
ing extra wiring for OEM alarm control.
24
(press "lock" button to program) - DEFAULT
(press "unlock" button to program)
(press "trunk" button to program)
(press "start" button to program)
(press "lock" & "unlock" button to program)
(press "lock" button to program)
(press "unlock" button to program) - DEFAULT
(press "trunk" button to program)
(press "start" button to program)
(press "lock" & "unlock" button to program)
(press "lock" button to program) - DEFAULT
(press "unlock" button to program)
(press "start" button to program)
(press "lock" button to program) - DEFAULT
(press "unlock" button to program)
(press "trunk" button to program)
(press "start" button to program)