The 1-Way Transmitter; Controller & Transmitter Functions - Excalibur AL-2060-EDPB Operation Manual

NOTE: The 2-way Controller is shipped from the factory in POWER OFF mode.
If you connect the charger before powering it, perform POWER OFF, then
POWER ON again.
POWER ON: Press and hold the "P" button for at least 1 second
POWER OFF: Press the "P" and "

THE 1-WAY TRANSMITTER

Part number: 1410-03
Call your dealer or visit www.caralarm.com to
order replacement transmitters.
Transmitter battery replacement:
Remove the small screw from the lower
back case, and separate the transmitter
halves� Replace the battery and reas-
semble the transmitter case�
Battery Types:
1410-03 - CR3032 (1 required)
LOCK / ARM: Press and release the "LOCK" button�
UNLOCK / DISARM: Press and release the "UNLOCK" button�
Controller & Transmitter Overview (cont'd)
*
" buttons for at least 1 second
Controller & Transmitter Functions
• THE SIREN WILL CHIRP & THE PARKING LIGHTS WILL
FLASH ONCE�
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL PLAY THE LOCK/ARM
ANIMATION AND BEEP ONCE
NOTE: PRESSING LOCK TWICE IN 5 SECONDS STARTS
THE PARKING TIMER. THE CLOCK WILL CHANGE TO
0:00 AND START COUNTING IN MINUTES & HOURS.
(1-WAY TRANSMITTER: PRESS THE LOCK BUTTON)
• THE SIREN WILL CHIRP TWICE & THE PARKING
LIGHTS WILL FLASH TWICE THEN ILLUMINATE FOR 30
SECONDS�
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL PLAY THE UNLOCK/
DISARM ANIMATION AND BEEP TWICE�
(1-WAY TRANSMITTER: PRESS THE UNLOCK BUTTON)
"lock"
button
"trunk"
button
"unlock"
button
"start"
button
5