Table of Contents
Advertisement
Installer Programmable Features (cont'd)
Feature #16 - Starter Interrupt Functions
Alarm Only
Anti-Grind Only
Alarm & Anti-Grind
Automatic
Alarm Only - The Starter Interrupt is operable whenever the alarm is armed�
Anti-Grind Only - The Starter Interrupt is operable whenever remote start is on�
Alarm & Anti-Grind - This setting engages starter interrupt when the alarm is armed AND when
the system is in remote start mode� This prevents the starter from grinding if the user accidentally
turns the key to "START" during remote start�
Automatic - This will cause the Starter Interrupt output to automatically engage 90 seconds after
the ignition switch is turned "off", and after disarming the system�
Feature #17 Low Temp Crank Extender
0ms (Off) (press "lock" button to program)
200ms
(press "unlock" button to program) - DEFAULT
300ms
(press "trunk" button to program)
400ms
(press "start" button to program)
When the vehicle's interior temperature is below freezing, this feature adds extra crank time to the
base timing (see installer feature #7)� It applies to tachless modes only (installer feature #3)�
Feature #18 - Arm, Disarm or Additional Channels
Arm / Disarm
Arm / Channel 5
Channel 4 / Disarm
Channel 4 / Channel 5
The system has outputs designed for arming and/or disarming a factory-equipped security system�
These wires may be used instead to provide further system outputs, which are remotely operated
by the controller or transmitter� These outputs are in addition to the 2nd channel and 3rd channel
outputs� As shown in the programming assignment, the arm, disarm, channel 4 and channel 5 are
programmable as various combinations. For example, if the disarm output is needed, but not the
arm output, then channel 4 may be made available for use�
Feature #19 - Horn Relay Functions
Horn Output
(press "lock" button to program) - DEFAULT
Ignition
(press "unlock" button to program)
Trunk Release
(press "trunk" button to program)
Pulse After Start
(press "start" button to program)
The primary function of this second relay, is to operate the vehicle's existing horn; either in
conjunction with the electronic siren, or in place of the siren� Using both the siren and the horn
creates an extremely effective security system. Optionally, if desired or needed, this relay can be
programmed for the other functions listed above�
This device complies with FCC Rules part 15� Operation is subject to the following
two conditions, (1) This device may not cause harmful interference and, (2) This
device must accept any interference that may be received, including interference
that may cause undesired operation�
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment�
26
(press "lock" button to program)
(press "unlock" button to program)
(press "trunk" button to program) - DEFAULT
(press "start" button to program)
(press "lock" button to program) - DEFAULT
(press "unlock" button to program)
(press "trunk" button to program)
(press "start" button to program)
Advertisement
Table of Contents
