Table of Contents
Advertisement
Changing The Programmable Features (cont'd)
STEP 4 - Press the transmitter button that corresponds to the setting you
desire. The horn will honk 1 time for LOCK, 2 times for UNLOCK, 3
times for TRUNK, and 4 times for "3RD CH".
STEP 5 - Repeat steps 3 and 4 if you need to change more than one feature.
The system will exit feature programming if 10 seconds passes with
no activity OR if the vehicle's ignition is turned on. This is indicated by two horn
honks and the status light will turn off.
FULL SySTEM RESET
You can return all programmable features to their factory default by entering
features programming (STEP 1 & 2), then immediately press the LOCK and
UNLOCK buttons simultaneously. The system will respond with 3 horn honks.
Programming Transmitters
STEP 1 - Make sure the system is in an unlocked state, not in valet mode, then
turn the vehicle's ignition ON.
STEP 2 - Within 7 seconds of STEP 1, press the Status Light/Valet Button 5
times. The horn will honk and the status light will repeatedly flash 1
time.
18
Advertisement
Table of Contents
