Programming Controllers/Transmitters; Programming Features - Excalibur AL-1775-3DB Operation Manual

Standard Programming: Using this method to program additional or replacement
transmitters does not turn on or otherwise affect the Unauthorized Transmitter Alert (UTA)
feature Before you begin, have all transmitters which are to operate the system at hand
and make sure the correct vehicle profile (see page 12) is selected on the controller(s).
Step 1 Then, turn the ignition "on"
Step 2 Within 5 seconds of Step 1, press the Valet Switch 5 times The siren/horn will
briefly sound, confirming that the system is ready to learn a transmitter code.
Step 3 Press the LOCK button on each transmitter one at a time The system will chirp
the siren/horn once to confirm that each was learned. If a code is not received within 10
seconds of Step 2, the learning process will automatically exit
If the Unauthorized Transmitter Alert feature is on, programming a transmitter to the
system will activate the "UTA" warning and the extended Status Light indication For the
next 48 hours, the siren/horn will sound a brief series of chirps every time the vehicle's
ignition key is turned on
Special Programming procedure to turn on the UTA feature: Use this method to
program transmitters or optional controllers, and to turn on the Unauthorized Transmitter
Alert feature
Follow the same steps as the Standard Programming, but on any transmitter/controller
being programmed instead of pressing the LOCK button, press the LOCK and the UN-
LOCK buttons together This action turns on the Unauthorized Transmitter Alert feature
and at the same time programs the transmitter or controller to operate the system
Once the Unauthorized Transmitter Alert feature is turned on, the warning will sound
for 48 hours after any transmitter programming, including the programming session which
was used to turn it on This feature can only be turned off again by sending the system
back to Omega for a reset
Step 1 Turn the ignition key "ON", then "OFF"
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user features
(10 times to access installer features)
~ The siren/horn will sound and the status light will turn on
Step 3 Within 10 seconds of step 2, press the valet switch the number of times corre-
sponding with the desired feature's number
~ The siren/horn will chirp, the status light, and the parking lights will flash equal
to the selected feature
Step 4 Change the feature by pressing the transmitter button that corresponds with
the desired setting The siren/horn will chirp to correspond with the chosen setting

Programming Controllers/Transmitters

Programming Features

15