Programming Controllers/Transmitters; Programming Features - Excalibur AL-1670-B Operation Manual

Standard Programming: Using this method to program additional or replacement
transmitters does not turn on or otherwise affect the Unauthorized Transmitter Alert (UTA)
feature� Before you begin, have all transmitters which are to operate the system at hand�
Step 1 Then, turn the ignition "on"�
Step 2 Within 5 seconds of Step 1, press the Valet Switch 5 times� The siren/horn will
briefly sound, confirming that the system is ready to learn a transmitter code.
Step 3 Press the LOCK button on each transmitter one at a time� The system will chirp
the siren/horn once to confirm that each was learned. If a code is not received within 10
seconds of Step 2, the learning process will automatically exit�
If the Unauthorized Transmitter Alert feature is on, programming a transmitter to the
system will activate the "UTA" warning and the extended Status Light indication� For the
next 48 hours, the siren/horn will sound a brief series of chirps every time the vehicle's
ignition key is turned on�
Special Programming procedure to turn on the UTA feature: Use this method to
program transmitters or optional controllers, and to turn on the Unauthorized Transmitter
Alert feature�
Follow the same steps as the Standard Programming, but on any controller being
programmed instead of pressing the LOCK button, press the LOCK and the UNLOCK
buttons together� This action turns on the Unauthorized Transmitter Alert feature and at
the same time programs the controller to operate the system�
Once the Unauthorized Transmitter Alert feature is turned on, the warning will sound
for 48 hours after any transmitter programming, including the programming session which
was used to turn it on� This feature can only be turned off again by sending the system
back to Omega for a reset�
Step 1 Turn the ignition key "ON", then "OFF"�
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user features
(10 times to access installer features)�
~ The siren/horn will sound and the status light will turn on�
Step 3 Within 10 seconds of step 2, press the valet switch the number of times corre-
sponding with the desired feature's number�
~ The siren/horn will chirp, the status light, and the parking lights will flash equal
to the selected feature�
Step 4 Change the feature by pressing the transmitter button that corresponds with
the desired setting� The siren/horn will chirp to correspond with the chosen setting�

Programming Controllers/Transmitters

Programming Features

13