Assa Abloy SARGENT IN120 Wi-Fi Series Installation Instructions Manual page 28

3 Installation of Connectors (Continued)
Important Note: If you are installing IN220 (PoE)*:
E. Pull 5 1/2 inches of Ethernet cable from hole. Strip cable jacket back
3 1/2 inches.
F. Separate (untwist) and straighten (8) Ethernet wires before carefully
feeding through ferrite bead (Fig. 3D).
G. Crimp RJ45 (male) connector on end of wires.
*For more detail, refer to section (7) 'Installation Wiring',
"A - Frame Harness Installation".
4 Installing the Controller
Apply dielectric grease to connector* located on back of Controller (FIG. 4B, C).
CAUTION - Do not allow debris to enter connector contacts.
Important Note: Before you install the controller
Fig. 4A
IN120 / IN220 Exit Device
RJ45-M
*Be sure to apply grease to connector and recessed area
Fig. 4B
28 1-800-810-WIRE • www.sargentlock.com • A8185D
Fig. 3D
Feed wires thru ferrite
bead (PoE only)
Crimp wires to
RJ45-M Connector
(PoE only)
surrounding connector
Fig. 4C