Box Weight And Size Capacities - 3M 40800 Instructions And Parts List

Specifi cations (continued)
(To re-locate upper frame or outer columns, see "Special Set-Up Procedure".)
Case Height Range Illustration
Upper Frame
Low Position
Minimum / Maximum
105mm
[4.125in] [24.8125in]
Operating
Range
Outer Column
Position 1
Upper Frame
High Position
Minimum / Maximum
235mm
[9.25in]
Operating
Range
Outer Column
Position 2
Note: Length of boxes in illustrations above are not to scale.
Special modifi cations may be available for carton sizes not listed on previous page.
Contact your 3M Representative for information.
Note: The case sealer can accommodate most boxes within the size range listed above. However, if
the box length (in direction of seal) to box height ratio is .6 or less, then several boxes should be
test run to assure proper machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL
Any box ratio approaching this limitation should be test run to assure performance.
700rks-NA
Minimum/Maximum Box Height Combinations
630mm
Box
Box
813mm
[32.00in]
Box
Box
BOX HEIGHT
Upper Frame
High Position
Minimum / Maximum
144mm 722mm
[5.6875in] [28.4375in]
Operating
Range Box
Box
Outer Column
Position 1
Upper Frame
Low Position
Minimum / Maximum
244mm 822mm
[9.625in] [32.375in]
Operating
Range Box
Box
Outer Column
Position 3
SHOULD BE GREATER THAN .6
=
16
Upper Frame
Low Position
Minimum / Maximum
152mm 730mm
[6.00in] [28.75in]
Operating
Range Box
Box
Outer Column
Position 2
Upper Frame
High Position
Minimum / Maximum
327mm 905mm
[13.25in] [36in]
Operating
Range Box
Box
Outer Column
Position 3
2010 January