3M 40800 Instructions And Parts List page 36

7-INSTALLATION AND SET-UP (continued)
Column Guards
Buffi ng
Cable
Roller
Note:
Column Guards
are removed
before
Installing the
Bumper Supports
(see Figure 2-6
and Figure 6-1).
Column Guards
are then reinstalled
(as shown in a ro-
tated 180° position)
Figure 7-7 – 700rks Frame Set-Up
7. Hold taping head BUFFING ROLLER and cut
and remove cable tie that holds applying/buffi ng
arms retracted (Applying/buffi ng rollers are held
retracted for shipment - See Figure 7-6). Allow
buffi ng/applying arms to extend slowly.
Also cut and remove cable tie at rear of lower
taping head.
WARNING
• To reduce the risk associated with sharp
blade hazards:
− Keep hands and fi ngers away from tape
cutoff blades under orange blade
guards. The blades are extremely sharp
8. Check for free action of both upper and lower
taping heads. Push buffi ng roller into head to
check for free, smooth action of taping heads.
700rks
C
Tie
• To reduce the risk associated with sharp
blade hazards:
− Keep hands and fi ngers away from tape
cutoff blades under orange blade
guards. The blades are extremely sharp
9. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down, as shown in Figure 7-8A. The
tape drum bracket assembly can be pivoted to
provide tape roll clearance in certain cases.
24
A
B
WARNING
2010 January