Table of Contents
Advertisement
4-SPECIFICATIONS (continued)
Specifications
6. Tape Roll Diameter
Up to 405mm [16 inch] maximum on a 76.2mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
7. Tape Application Leg Length – Standard
70 mm ± 6mm [2.75 inch ±. 25 inch ]
Tape Application Leg Length – Optional
50 mm ± 6mm [2 inch ±. 25 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")
8. Box Board
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)
9. Box Weight and Size Capacities
A. Box Weight, fi lled: 5 lbs.–85 lbs. [2.3 kg–38.6 kg]. Contents must support fl aps.
B.
Box Size:
Length –
Width –
Height –
*
Minimum box height can be reduced to 110mm [4-1/4 inches] by removing machine compression rollers OR
Minimum box height can be reduced to 90mm [3 1/2 inches] by removing machine compression rollers and
also adjusting taping heads to apply 48mm [2 inch] tape legs (See "Special Set-Up Procedure".)
**
Maximum box height can be increased to7 25mm [28-1/2 inches] by relocating machine outer columns to
upper position. (See "Special Set-Up Procedure".)
Note: Raising columns to upper position also increases minimum
box height to 210mm [8-1/4 inches].
Note: The case sealer can accommodate most boxes within the size range listed above. However, if the box
length (in direction of seal) to box height ratio is 0.6 or less, test run several boxes to ensure proper
machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL
Any box ratio approaching this limitation should be test run to ensure performance.
800a3-NA
Minimum
150mm [6.0 inch]
140mm [5.5 inch]*
120mm [4.75 inch]** ***
BOX HEIGHT
®
fi lm tapes.)
Maximum
Unlimited
545mm [21.5 inch]
620mm [24.5 inch] ***
=
SHOULD BE GREATER THAN 0.6
13
2011 September
Advertisement
Chapters
Table of Contents
Troubleshooting
