Set Country Selection; Set Language - GE Dash 3000 Service Manual

Set Country Selection

Set Language

French language information
Czech, Hungarian, Polish, or Russian language information
Chinese and Japanese language information
4-20
Configuration: Boot Code settings
Select DEFAULT or FRANCE to choose a particular set of GE factory
defaults.
1. Activate Boot Code
SET CONFIGURATION menu option.
2. Select Country Selection and choose language.
3. Select Exit and wait for the patient monitor to display the message,
"Writing settings to Flash config mem..."
4. Manually reboot the patient monitor to implement this change.
Select Set Language to change the language of the displayed text.
1. Activate Boot Code
SET CONFIGURATION menu option.
2. Select the SET LANGUAGE menu option.
3. Select the appropriate language.
4. Manually reboot the patient monitor to display the new language.
When the patient monitor Locale (language) is set to French_France,
alarm pause duration is three minutes. Refer to the Alarms chapter in
the operator's manual.
Special characters within alarm broadcasts, messages, patient name, site
name, or location fields that are sent over the optional CARESCAPE
Network cannot be displayed by equipment that does not support these
languages. Special characters may appear as either blanks, asterisks, a
series of square boxes, or no character is displayed at all because the
ability to display Cyrillic (Russian alphabet) and special Czech,
Hungarian, or Polish characters does not exist on this equipment.
When the patient monitor Locale (language) is set to Chinese or
Japanese, the following conditions apply:
Text for alarm broadcast over the optional network is in English.

All text input is in English only (e.g., text for unit name, bed name,

patient information, and custom default name).
Dash 3000/4000/5000
("Boot Code settings" on page
("Boot Code settings" on page
4-18) and select
4-18) and select
2000966-542D