Get Error Logs; Get Logs Via Pc Using Netupdate - GE Dash 3000 Service Manual

Get error logs

Get logs via PC using netUpdate

Requirements
6-16
Troubleshooting: Get error logs
These instructions describe how to copy log files from a Dash 3000/4000/
5000 patient monitor to a PC using one of the following configurations:
PC or PC laptop connected to a Dash 3000/4000/5000 patient monitor

PC or PC laptop connected to the MC network.

CAUTION
LOSS OF MONITORING — There may be a temporary
loss of monitoring functions until the log file retrieval is
complete. Do not copy logs while a patient monitor is
connected to a patient. Medical staff should be prepared
to cover patients in need during these periods of lost
monitoring functions.
PC to patient monitor or Dash Port 2
One patient monitor software upgrade CD-ROM V6.5 or later.

® ®
Microsoft Windows XP operating system

CD-ROM drive

Network card

Pentium II processor or higher

Minimum 64 MB of RAM

Category 5 crossover patch cable
(pn 415480-001)
NOTE
You must be able to change the IP address on the PC.

If you are using a PC laptop with a docking station, remove the laptop from the docking

station before you begin the log transfer.
If you are using a PC with a wireless network connection, remove or disable the

wireless network card before you begin the log transfer.
If the patient monitor is using a Dash Port 2, remove the patient monitor from the

docking station before you begin the log transfer.
Dash 3000/4000/5000
PC to MC network
Category 5 network patch cable
2000966-542D