GE Dash 3000 Service Manual page 133

Connect the PC to Dash patient monitor or MC network
2000966-542D
Troubleshooting: Get error logs
NOTE
Connect the patient monitor and PC to a reliable power source
during the transfer process. Do not use battery power. A battery
failure during the transfer process may result in a transfer process
failure.
1. Connect one end of the category 5 crossover or network patch cable to
the PC network card.
2. Connect the other end of the category 5 crossover patch cable as
follows:
Connect to the ETHERNET port of the docking station if the

patient monitor is using a Dash Port 2 docking station.
Connect to the ETHERNET port of the patient monitor if no

docking station or network is used.
Connect to the MC network Ethernet tap if transferring logs

from other devises on the network. If you connect directly to the
MC network Ethernet tap, verify that the patient monitor or
docking station is also connected to the MC network Ethernet
tap.
3. Power on the PC.
4. Continue with the instructions,
page 6-18.
Dash 3000/4000/5000
"Change the PC's IP address" on
6-17