Table of Contents
Advertisement
Simrad SN90 Operator Manual
• The communication parameters required for the sensor interface are known.
Context
The
page provides two lists; one for serial ports and one for Ethernet
I/O Setup
(LAN) ports. Each list is supported with a set of functions to set up and monitor the
communication ports. Select the port you want to work with and then select one of
the buttons below the list.
Tip
The
page in the
Sensors
of all the communication lines and sensors in use. All relevant status information is
provided. You open the
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Procedure
1
Open the
Setup
2
On the
menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3
On the left side of the
4
Observe that the available serial and network interface ports on the Processor Unit
are listed.
5
Set up the relevant serial or Ethernet (LAN) communication parameters.
a
Select the interface port you wish to set up.
b
Select
Setup
dialog box.
c
Set up the relevant serial or Ethernet (LAN) communication parameters.
The communication parameters defined for
•
Baud Rate
•
Data Bits
•
: None
Parity
•
Stop Bits
Some instruments may offer other parameters and/or options. You must always
check the relevant documentation provided by the manufacturer.
d
Select
OK
134
(Built-In Test Equipment) dialog box provides an overview
BITE
dialog box from the
BITE
dialog box, you must always select
Installation
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
below the list to open the
: 4800 bit/s
: 8
: 1
to save the selected settings and close the dialog box.
menu.
Setup
.
I/O Setup
Serial Port Setup
NMEA 0183
to save the
Apply
.
or
LAN Port Setup
are:
381295/B
Advertisement
Table of Contents
