Table of Contents
Advertisement
User Setting Buttons
Panel. The
Operating Panel
: Press one of the
D
F1 F2 F3
which function to apply open the
assign one function to each
: Press this button to make a copy of the current SN90 presentation.
Screen Capture
You can choose either a single screen capture or a sequence with multiple screen
captures. Open the
: Press the joystick forward to increase the tilt angle in the active view. Turn
E
Joystick
the button on the top of the joystick to change the bearing in the active view.
F
: These buttons correspond to the two most common buttons on a
Mouse buttons
standard computer mouse. When an instruction tells you to "select" or "left-click",
press the left button. When an instruction tells you to "right-click", press the right
button.
A hull unit may be provided as an optional method to lower and hoist the transducer.
G
Use these buttons to lower and hoist the transducer. While the transducer is moving
the indicator lamp flashes, and an audible signal is sounded. When the requested
position has been reached, the indicator lamp is lit, and the audible signal stops.
•
: Press
Up
Up
•
: Press
Middle
•
: Press
Down
: Turn a rotary switch to apply a predefined function. To choose
H
Rotary switches
which function to apply open the
, assign one function to each rotary switch on the Operating Panel.
Options
Use these buttons to place markers in the current active view.
I
•
: Press
Marker
markers can be placed in the view to identify specific echoes. Each marker
is shown as a small triangle with or without a short identifying label. It is
positioned based on the two known axes in the view as well as the tilt and
bearing of the current ping.
•
Circle Marker
The circle is drawn with the same diameter as your purse. By means of the circle
you can see the size of the school relative to your purse.
•
: Press
Gear
Gear
provided as a tool to help you plan and shoot the purse seine. The symbol is
intended to be used in a structured sequence that starts when you plan to shoot
the purse seine.
Press these buttons to start position or target tracking.
J
•
Position Track
interface.A position track permits the SN90 to automatically control the tilt and
bearing based on the movements of your vessel. It locks on a position defined by
381295/B
, assign one predefined setting to each button on the Operating
page is located in the
buttons to apply a predefined function. To choose
Fx
Operating Panel
button on the Operating Panel.
Fx
dialog box to select screen capture mode.
Screen Captures
to hoist the transducer to its upper position.
to place the transducer in a predefined middle position.
Middle
to lower the transducer to its bottom position.
Down
Operating Panel
to place a generic marker in the active view. One or more
Marker
: Press
Circle Marker
to place a gear symbol in the active view. The gear symbol is
: Use the trackball to control the cursor in the SN90 user
Installation
page. Under
page. Under
to place a circular marker in the active view.
Getting started
dialog box.
,
Button Options
Rotary Switch
23
Advertisement
Table of Contents
