Table of Contents
Advertisement
Simrad SN90 Operator Manual
Procedure
1
Click in the view you want to activate.
The active view is identified with a thicker border. Unless you use the
function, all changes you make will only be applied to this view.
2
Turn the relevant rotary switch to make the adjustment.
Tip
The Operating Panel is fitted with three rotary switches. The switches are identified
with numbers. Each switch can be assigned a function related to range, gain or
bearing. Investigate the functionality provided on the
page is located in the
Optionally:
3
In a Horizontal view, select the bearing line and drag it sideways.
Optionally:
4
Observe the
Main
Its default location is on the right side of the SN90 presentation.
5
Select
.
Bearing
6
Make the necessary adjustment.
The following methods can be used to adjust this setting:
a
Select [+] or [-] to choose the requested setting.
b
Place the cursor on the button. Press and hold the left mouse button. Move the
cursor horizontally over the button. Release the mouse button when requested
value is shown.
c
Select the middle of the button to open it. If you have a keyboard connected to
the SN90, type the requested value.
7
Open the button and select
the views in the current presentation mode.
Related topics
Controlling the gain and range settings, page 63
70
dialog box.
Installation
menu.
Apply to all
Operating Panel
if you wish to use the chosen setting in all
Apply to all
page. This
381295/B
Advertisement
Table of Contents
