Assigning Functions To F1, F2 And F3 On The Operating Panel - Simrad SN90 Operator's Manual

Assigning functions to F1, F2 and F3 on the Operating Panel

The Operating Panel is fitted with three function buttons. The buttons are identified as
, and . Each button can be assigned a dedicated function.
F1 F2 F3
Context
The
Operating Panel
physical hardware panel you use on your SN90, and
to assign functionality to the programmable buttons.
This page is located in the
dialog box is located on the
Installation
The three function buttons are grouped with the
button.
Capture
Note
The SN90 supports two different operating panels. These
are referred to as "Mk1" and "Mk2". In this publication
all descriptions and references are related to "Mk2".
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
pages selected from the menu on the left side.
3 On the left side of the
4 Select which operating panel to use.
5 Under
Button Options
The following functions can be controlled:
• Auto Tilt: This is an "on/off" function. In Auto Tilt mode the beam automatically
changes the tilt angle for each ping. The centre of the tilt sector is defined by the
chosen tilt angle just before the Auto Tilt mode is started. The chosen tilt sector
is shown on the tilt indicator in the Horizontal view using a shaded background.
• Off Centre: This is the same function as
menu. Place the cursor anywhere in the view and press the button. The function
moves the vessel symbol to the selected position.
• Zoom: Place the cursor anywhere in the view, right-click and select
one zoom level is provided. Select
view.
381295/B
page is used to select which
dialog box. The
Installation
Setup
menu.
Installation
menu opens. This dialog box contains a number of
Installation
dialog box, select
Installation
, assign one function to each
menu.
Screen
.
Operating Panel
button on the Operating Panel.
Fx
Set New Ship Centre
one more time to restore the original
Zoom
Operating procedures
.
on the shortcut
. Only
Zoom
123