Table of Contents
Advertisement
Simrad SN90 Operator Manual
its latitude, longitude and depth. The bearing and tilt settings are automatically
adjusted to compensate for the movements of your vessel.
•
: A target track permits the SN90 to automatically control the tilt and
Target Track
bearing based on the movements of the chosen target. It locks on the target
defined by its position, heading and speed. The bearing and tilt settings are
automatically adjusted to follow the movements of the tracked target.
A new tracked object is automatically given priority status. Relevant information
about the priority object can be found in the lower left corner of the view. If you
change the tilt or bearing settings manually the priority status is lost.
: Use the trackball to control the cursor in the SN90 user interface.
K
Trackball
Note
The SN90 supports two different operating panels. These are referred to as "Mk1" and
"Mk2". In this publication all descriptions and references are related to "Mk2".
Before you can change the settings related to a view, you must click inside the view to
activate it. The changes you make are by default only valid for the active view. Several
of the functions offer
the views in the current presentation mode.
24
. If you select
Apply to All
your setting is applied to all
Apply to All
381295/B
Advertisement
Table of Contents
