Connecting And Configuring The Projector - Epson PowerLite 9300i User Manual

caution
You must use a category 5
shielded twisted-pair cable
to connect to the LAN to
prevent malfunction.
note
Make sure the
Standby
setting in the
Mode
Advanced1 menu is on, or
you won't be able to view or
change the projector's
network settings.
Managing the Projector from a Remote Computer
84
Connecting and Configuring the
Projector
Before using the EMP software to manage your projector(s), you have
to connect each projector you want to monitor to your network and
configure it with an appropriate IP address.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT category 5 shielded twisted-pair
network cable.
Connect the cable to the ethernet port on the projector as shown.
Ethernet port
To network port
2. Turn on the projector (see page 36).
3. Press the button on the remote control and select
Menu
from the
Advanced2
Video
Projector ID
Audio
Network
Effect COM Port
Setting
Auto Setup
User's Logo
BNC Sync Termination
Direct Power ON
Advanced1
Advanced2 Reset
About
Reset All
[ ]: Select [ ]: Enter
4. If your network assigns addresses automatically, turn on
menu.
: 1 :
Set
Set
: RS-232C USB
:
ON OFF
:
ON OFF
:
ON OFF
Execute
[Menu]: Exit
Network
Select Network
.
DHCP