Connecting And Configuring The Projector - Epson PowerLite 8300NL User Manual

note
Make sure the
Standby
setting in the
Mode
Advanced1 menu is off, or
you won't be able to view or
change the projector's
network settings.
Managing the Projector from a Remote Computer
76
Connecting and Configuring the
Projector
Before using the EMP software to manage your projector(s), you have
have to connect each projector you want to monitor to your network
and configure it with an appropriate IP address.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT network cable.
Connect the cable to the ethernet port on the projector as shown.
Ethernet port
To network port
2. Turn on the projector (see page 32).
3. Press the button on the remote control and select
Menu
from the
Advanced2
Video Video
Brightness Control
Audio
Projector ID
Eff Effect
Network
Setting Setting COM Port
User's Logo User's Logo Auto setup
Advanced1 Adv BNC Sync Termination
Adv Advanced2 Reset
About About
Reset All Reset All
[ ]: Select Select [ ]: Enter Enter
4. If your network assigns addresses automatically, turn on
menu.
:
High Low
: 1
Set
Set
: RS-232C USB
:
ON OFF
:
ON OFF
Execute
[Menu]: Exit
Network
Select Network
.
DHCP