Epson PowerLite 9300i User Manual page 113

If you just replaced the lamp, make sure the lamp is fully inserted
■
and the cover securely reattached, or the projector won't come on.
■ If you just turned off the projector, it may still be cooling down.
Wait until the power light stops flashing and remains orange; then
press the P
Power
You see the message
Make sure the cables are connected correctly, as described in
■
Chapter 1.
If you've connected a video player, make sure it's turned on and
■
playing.
If you've connected a notebook computer, make sure it's set to
■
display on an external monitor (see page 39).
■ You may need to select the image source (the projector port to
which your equipment is connected). To switch sources, press the
corresponding
Source
(see page 38). Allow a few seconds for the projector to sync up
after pressing the button.
You've connected a notebook, but the projector and
notebook don't display the same image.
You have to enable your notebook to display both on its LCD
■
screen and through its external monitor port (see page 39).
You see the message
Make sure the correct
■
menu (see page 75). It should normally be set to
Make sure your computer's resolution doesn't exceed UXGA
■
×
(1600 1200), and the frequency is supported by the projector.
If necessary, change your computer's resolution to a compatible
setting (see page 126).
button to turn the projector back on.
displayed.
No Signal
button on the projector or remote control
displayed.
Not Supported
is selected in the Video
Video Signal
.
Auto
Solving Problems
113