Setting the Remote Control ID
The remote control's default ID is zero. If you need to change it,
follow these steps:
1. Press the
button on the remote control. You see it light up.
ID
2. Press one of the numbered buttons on the remote control to select
the desired ID (0 through 9). Select zero to control all projectors,
or select a number to match the ID of the projector(s) you want to
operate.
The
button's light shuts off and the new ID is registered.
ID
If you would like to check the remote control's current ID, do the
following:
1. Press the
button twice in succession. After a moment, the
ID
button flashes.
2. Count the number of flashes; this number corresponds to the
remote control's ID. (If it doesn't flash, it is set to zero.)
Nine
Zero
0
Giving Your Presentation
53