Connecting And Configuring The Projector On A Wired; Network - Epson PowerLite 830p User Manual

note
If you're a network
administrator, you can use
the option to enter a
SNMP
trap IP address. This lets you
receive trap alerts for the
projectors you're monitoring.
Managing Projectors
80
Connecting and Configuring the
Projector on a Wired Network
Before using the EasyManagement software to manage your
projector(s), you have to connect each projector you want to monitor
to your network and configure it with an appropriate IP address. You
can connect and configure the projector using the network port.
Follow these steps to connect and configure the projector for your

network.

1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT network cable.
2. Turn on the projector (see page 18).
3. Press the button on the remote control and select
Menu
from the
Extended
4. If your network assigns addresses automatically, turn on
If your network does not assign addresses automatically, turn off
and enter the projector's
DHCP
Gateway Address
To enter numbers using the remote control, press the
button until it lights, then use the number keypad shown
below.
menu.
IP Address
, as needed.
Network
.
DHCP
, , and
Subnet Mask
Num