Epson PowerLite 9300i User Manual page 95

You can give the projector a name—up to 15 characters
■
long—using alphanumerics only, including the hyphen (-).
Naming the projector helps you identify it in EMP Monitor
and EMP NetworkManager. This is especially useful if you're
managing more than a few projectors.
5. Click
Mail Notification Settings
You see this screen:
6. Select for the Mail Notification setting.
ON
7. Enter the IP address and port number of the SMTP server used
for sending e-mail. (The port's default setting is 25, but you can
enter any number from 1 to 65535.)
8. Enter up to three e-mail addresses where you want the event
notification messages to be sent.
9. Click the
Setting a Notification Event
address, then select the conditions under which you want a
message to be sent.
10. Click , then on the next screen click
OK
11. When you see the test message window, you can send a message
with the heading "TEST MAIL" to the addresses you have
entered. The projector's name and IP address are included in the
body of the message.
12. When done making all your projector settings, close the EMP
NetworkManager. (It does not have to be open for messages to be
sent or received.)
.
button next to each
. Confirm as needed.
Set
Managing the Projector from a Remote Computer
note
A no-signal message is
reported when no image
signals are being input to a
projector. If the projector
will not normally be
displaying an image, do not
select 'no signal' as a
condition for which you
want a message to be sent.
95