Shutting Down The Projector - Epson PowerLite 9300i User Manual

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If you've connected a computer or notebook, shut it down first;
otherwise you may not be able to see your computer's display to
shut it down properly.
2. To turn off the projector, press the red
projector or remote control.
You see a confirmation message. (If you don't want to turn it off,
press any other button.)
3. Press the button again. The power light flashes orange for
Power
about a minute as the projector cools down. After the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
4. Turn off and disconnect any equipment plugged into the
projector.
5. If you extended the feet, press the side buttons to retract them.
6. Replace the lens cap and unplug the power cord.
button on the
Power
Power button
button.
Power
Displaying and Adjusting the Image
note
When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
"sleep mode." This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the button. If
Power
you are done using the
projector, unplug the power
cord. To turn off sleep mode,
see page 77. If
Standby
has been set to
Mode
(see page 76),
Network ON
the lamp will turn off but
the projector will not go into
full sleep mode.
Power OFF?
Yes : Press button
No : Press any other button
caution
To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.
47