Table of Contents
Advertisement
5 - 10
Cables to MAMMOMAT generator (and printer if present)
To lay the cables, proceed as follows:
1.
2.
3.
Fig. 9
Cable-duct compartments
Opdima?
Installation
Disconnect the printer cable (if connected) from the MAMMOMAT generator.
Open the cable duct between the generator and the stand and lift up the cable (if
present).
The cable will be reused to connect the printer to X205 on the biopsy controller.
Place the new cable with connectors marked X206 and X2 in the cable duct
between the generator and the biopsy controller. Use compartment according to
the figure below.
Cable X206-X2
Register 3
Serial number higher than 3000
Serial number lower than 3000
SPB7-230.033.10
Rev. 03
08.02
Installation
Page 10 of 26
Siemens-Elema AB
SPS-UD
5
Solna, Sweden
Advertisement
Table of Contents
