Monitoring - Idis DR-6100P Series Operation Manual

– Stop: Once mirroring starts, you can stop it by
selecting Stop option and then designating disks
to delete. Once mirroring is stopped, all existing
data on the disk will be erased.
When mirroirng is stopped, the deleted disk will be set
to NOT Used. If you want to use the disk for recording,
you must reformat it.
Mirror number 1 and 2 cannot resynchronize at the
same time.
– Resync: Once you start mirroring, the two disks
will be resynchronized, which means that all data
on the destination disk will be erased and the data
on the source disk will be copied to the destination
disk. Select the Resync option, designate the
source disk, and then click OK. When you click OK,
all data on the destination disk will be erased. After
resynchronization is complete, mirroring will start.
When you try resynchronizing, the disk that has never
tried mirroring cannot be selected as the source disk.
Once you start mirroring, all data on the destination
disk that designate as the source disk will be erased.
Please be careful not to designate the wrong disk by
mistake.
● Information: Indicates if the installed disk is being
used for mirroring or Resync purposes. Select
information about mirroring to check the disk's model
and serial number.

Monitoring

Use this option to configure Monitoring settings.
● Settings: Configure when and what the system
should monitor for.
● Actions: Configure alarm-out (NVR alarm-out
channel, NVR beep, camera alarm-out channel) and
notification (email, LAN1 through 5, SNS, push, alert
window) settings.
Part 2 - Configuration
37