Storage - Idis DR-6100P Series Operation Manual

Part 2 - Configuration
● Panic Record: Displays event status based on current
Panic Record status.
● Check Recording: Displays event status based on
System Monitoring settings. For more information,
refer to the Monitoring on page 37.
● Disk Almost Full/Disk Full: If the storage device
is not in Recycle status, event status is displayed
when the amount of disk space specified under
System Monitoring is reached and when the disk
becomes 100% full. For more information, refer to the
Monitoring on page 37.
● Fan Error: Event is indicated when the cooling fan
cannot reach a certain RPM or fails for longer than 50
seconds.
● eSATA Disconnected: Event status is displayed when
an eSATA device is abruptly disconnected.
● Disk Config Change: It will be highlighted when
the NVR reboots after the hard disk drive has been
replaced.
● No Storage Found: It will be highlighted when no
recordable storage device has been found.
76

Storage

Indicates each disk's status.
Configure Disk Bad and Disk Temperature settings under
Setup > System > Monitoring.