Alarm-In; Video Loss - Idis DR-6100P Series Operation Manual

Alarm-In

● No.: Enable / disable alarm-ins.
This option includes both local and network camera
alarm-ins. 1 through 32 are network camera alarm-ins,
whereas 33 through 36 are local alarm-ins.
● Title: Use the virtual keyboard to enter titles.
● Type: Change the alarm-in type.
● Actions: Specify which actions to take when Alarm-In
is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, SNS, Push, and/or Alert Window.
– EventUpload: Uploads the video clips when an
event occurs.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
• In order to use the Callback feature, the NVR must
be registered on the remote program.
• Select Panic Record to specify which alarm-in
channels to use. Panic Record commences when
the corresponding alarm-in occurs and terminates
when the alarm-in is deactivated.

Video Loss

● Activation Time: Specify how long video loss has
to last in order for it to be considered as an event.
When the video loss is not detected for the specified
duration of time, it will not be considered as an event.
● Actions: Specify which actions to take when a Video
Loss event occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, SNS, Push, and/or Alert Window.
– EventUpload: Uploads the video clips when an
event occurs.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Select the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
● Analog Camera: Detect a video loss event for the
analog cameras connected to the video encoder.
– Ignoring Interval: The system does not produce
event log entries or issue remote notifications for
video loss detected for the time specified after
the initial video loss was detected. Set the value
between 0.1 and 15 seconds or choose Never.
– Use Ignoring Time: Select Time Setup to specify
the time to ignore video loss detection. Video
loss detection will be disabled for a specified time
period.
Part 2 - Configuration
59