Zoom; Ptz Control; Dewarping Control - Idis DR-6100P Series Operation Manual

Part 1 - Getting Started

Zoom

Press the ZOOM button on the remote control or right-
click on the mouse to select a channel you wish to zoom
in on while in live mode or time-lapse mode. When a
zoom frame appears on the selected channel, right-click
on the mouse or press the Enter button to zoom in. Use
the arrow buttons to position the frame. When Zoom
icon is on the status bar located on the
is activated,
upper right corner of the system.
• In Full Screen mode, activating Zoom automatically
selects the current channel.
• To restore the channel to normal size, press the
Zoom button again.

PTZ Control

While in Live mode, right-click and select PTZ from the
context menu or press the PTZ button on the NVR's
front panel or remote control to display the PTZ camera
selection window.
Select the camera you wish to control. The
begin to flash on the selected camera's OSD window.
Use the Arrow buttons to pan and tilt the camera up,
1
down, left, and right.
1
2
1
1
1
Use the and
2
1
3
2
2
2
Use the and
2 3
4
3
3
3
nearby to far and vice versa.
3 4
5
4
4
4
Use the button to load the preset window.
4 5
6
5
5
5
Use the button to save current position as a
5 6
6
6
6
preset.
6
24
icon will
buttons to zoom in/out.
buttons to shift focus from
You can also change the direction by dragging on the
mouse.
Also, it's possible to use the mouse wheel to zoom in/
out.
• Logging in with an account that has PTZ Control
Authority is necessary in order to control PTZ
cameras.
• A message will prompt if there is no PTZ camera
displayed on the Live screen.
• Zoom in/out and shift focus using the PTZ Control
(ZOOM, FOCUS) buttons on the remote control.
• To exit PTZ mode, press the PTZ button again.

Dewarping Control

While in Live mode, right-click and select Dewarping
from the context menu. The
on the selected camera's OSD window. You can change
the direction by dragging on the mouse. In order to
select dewarping type and mode, Video (Camera -
Advanced Setup) must first be enabled.
• This feature is supported only with Fisheye camera
connected on the DirectIP protocol.
• Original mode does not support dewarping control
feature.
icon will begin to flash