General; Advanced Setup - Idis DR-6100P Series Operation Manual

Part 2 - Configuration

General

Enable/disable the covert view and rename cameras.
● Title: Edit the camera's name.
● Use: Set the camera as Normal, Covert 1, or Covert 2.
Live images and video recordings from cameras that
have been set as Covert 1 or Covert 2 will not be
available to users who do not have covert camera
access. Setting a camera as Covert 1 hides its images
but does display OSD information about the camera.
Setting a camera as Covert 2 hides its images as well
as ODS information about the camera as if it has been
deactivated completely.
● Use Real Time Mode: Supports seamless video
display even when there are multiple camera
connections. (Only for the DR-6232P and DR-4216P)
• If you have configured Use Real Time Mode, the
streaming settings may change for all registered
cameras. Some settings may be disabled.
• If you have configured Use Real Time Mode, the
remote streaming IPS can be low.
42

Advanced Setup

Configure security and other advanced camera settings.
● Video: Adjust the camera image sensor settings such
as white balance and exposure. Configuration options
may differ depending on the camera model.
● Privacy Masking: Enable/disable and configure
privacy masking for the camera.
● SSL: Set the camera's security level as Unavailable,
Standard, High, or Very High. Standard, High and
Very High settings apply SSL (Secure Sockets Layer)
protection to the camera.Reset: Resets the port or
cameras.
– PoE Reset: Control the PoE Switch's port. This
option is available when connecting to Video In/
PoE port or using a DirectIP™ PoE Switch (optional).
Select PoE Reset to reboot the camera. It is not
supported by video encoders.
– Soft Reset: Reboots the camera.
– Factory Reset: Resets the NVR to all its initial
factory settings. It is supported by DirectIP™
cameras only.
● Mode: Select a resolution mode. This is supported by
video encoders only.
● PTZ: If using an RS-485-compliant camera, configure
it for use in PTZ Mode.