Wiring Examples For The Factory Settings - Siemens SINAMICS G120 Operating Instructions Manual

Commissioning
4.3 Commissioning with factory settings
4.3.1

Wiring examples for the factory settings

To ensure that the factory setting can be used, you must wire the terminal strip of your
inverter as shown in the following examples.
Pre-assignment of the terminal strip for the CU240B-2
Figure 4-2
Pre-assignment of the terminal strip for the CU240B-2 DP
Figure 4-3
64
Wiring example to use the factory settings
Wiring example to use the factory settings
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2011, FW 4.4, A5E02299792B AB