Setting The Address - Siemens SINAMICS G120 Operating Instructions Manual
Frequency converter
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
6.1.2
Setting the address
You can set the inverter's PROFIBUS address using either DIP switches on the Control Unit
or parameter p0918.
Valid PROFIBUS addresses:
Invalid PROFIBUS addresses:
If you have specified a valid address using DIP switches, this address will always be the one
that takes effect and p0918 cannot be changed.
If you set all DIP switches to "OFF" (0) or "ON" (1), then p0918 defines the address.
The positions and settings of the DIP switches are described in Section: Interfaces,
connectors, switches, terminal blocks and LEDs of the CU (Page 43).
CAUTION
A bus address that has been changed is only effective after the inverter has been switched
off and back on again.
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2011, FW 4.4, A5E02299792B AB
6.1 Communication via PROFIBUS
1 ... 125
0, 126, 127
Configuring the fieldbus
103
Advertisement
Table of Contents
