Technical Data, Pm260 - Siemens SINAMICS G120 Operating Instructions Manual

10.3.3

Technical data, PM260

General data, PM260 - IP20
Feature
Line voltage
Input frequency
Power factor λ
Starting current
Pulse frequency
Electromagnetic compatibility
Braking method
Degree of protection
Operating temperature
● without power reduction
● with power reduction
Storage temperature
Relative humidity
Environmental requirements
Shock and vibration
Electromagnetic radiation
Installation altitude
● without power reduction
● with power reduction
Standards
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2011, FW 4.4, A5E02299792B AB
Version
3-ph. 660 V ... 690 V AC ± 10%
The permissible line voltage depends on the installation altitude
The power units can also be operated with a minimum voltage of 500 V –10 %. In this
case, the power is linearly reduced as required.
47 Hz ... 63 Hz
0.9
Less than the input current
16 kHz
The devices are suitable for environmental classes C1 and C2 in conformance with
IEC61800-3. For details, see the Hardware Installation Manual, Appendix A2
DC braking, energy recovery (up to 100% of the output power)
IP20
LO operation: 0 °C ... +40 °C (32 °F ... 104 °F)
HO operation: 0 °C ... +50 °C (32 °F ... 122 °F)
HO/LO up to 60 °C (140° F), for details see the Hardware Installation
Manual
-40 °C ... +70 °C (-40 °F ... 158 °F)
< 95% RH - condensation not permissible
Protected according to environmental class 3C2 to EN 60721-3-3 against damaging
chemical substances
Do not allow the inverter to fall and avoid it being subject to hard shocks. Do not
install the inverter in an area where it could be continuously subject to vibration.
Do not install the inverter close to sources of electromagnetic radiation.
Up to 1000 m (3300 ft) above sea level
up to 4000 m (13000 ft) above sea level, for details see the Hardware Installation
Manual.
CE, C-TICK
Technical data
10.3 Technical data, Power Modules
277