Table of Contents
Advertisement
4.10 Operations after printing
This section describes the media cutting procedures.
4.10.1 Cutting media
This section explains how to cut roll media.
4.10.1.1 8264E Cutting media
•
When printing is finished, the media guide is hot. Wait until the media guide cools off.
Follow the procedure below to cut roll media.
1. Verify the following regarding the operational condition of the printer.
•
Printing or other operations are not in progress.
•
"Ready to Print" is displayed in the control panel.
2. If the roll media cut position is changed, refer to
the desired cut position.
3. Open the front cover.
No.
1
•
Pay attention to the following points when you cut roll media. Mishandling the
razor blade may cause a cut on your finger or hand.
•
When you hold media, do not place your finger on the media cut groove.
•
Move the razor blade along the media cut groove.
8254E / 8264E User Guide
Front cover
4.8.1 Feeding media
Name
and advance the roll media to
163
Advertisement
Table of Contents
Troubleshooting
