Time-Date - Honeywell NOTIFIER SFP-10UD Series Manual

Master Programming Level
SYSTEM SETUP
1=TIMERS
2=BANNER

3=TIME-DATE

System Setup Screen #1
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C2 1/24/2012
Time-Date
The control panel time and date can be changed by pressing 3 while viewing the System Setup
Screen #1. The following screen will be displayed:
1=TIME
2=DATE
3=CLOCK FORMAT
1=DAYLIGHT SAVINGS
Time

To change the time, press 1 while viewing the Time-Date Screen. The following screen will be dis-
played:
ENTER TIME AS 12HRS
1=AM
A flashing cursor is located toward the top left of the display. Below the cursor is the current time.
To change the time, enter the two-digit hours followed by the two-digit minutes. The cursor will
move one position to the right each time a digit is entered. After the last minutes digit is entered,
the cursor will again move one position to the right. At this point enter 1 for AM or 2 for PM. The
display will then return to the Time-Date Screen which will show the new time entry. If an error is
made while entering a digit, press the CLR key to delete the entire entry and beginning again.
Date

To change the date, press 2 while viewing the Time-Date Screen. The following screen will be dis-
played:
A flashing cursor is located toward the top left of the display. Below the cursor is the current date.
To change the date, enter the two-digit month followed by the two-digit day and then the two-digit
year (07 for 2007, 08 for 2008, etc.). The cursor will move one position to the right each time a
TIME AND DATE
10:00 AM
07072007
Time-Date Screen #1
TIME AND DATE
Time-Date Screen #2
10:00 AM
Time Screen
ENTER DATE
**-**-****
MONTH DAY YEAR
07-07-2007
Date Screen
12HR
2=PM
Programming
79