Honeywell NOTIFIER SFP-10UD Series Manual page 94

Programming
The following table lists the Zone Alarm Types that can be programmed for zones 1 through 10 and
the corresponding Event Codes for Ademco Contact ID and SIA DCS Formats. Note that Table 3.4
on page 95, Table 3.5 on page 96, Table 3.6 on page 97 and Table 3.7 on page 99 list the default set-
tings for Zone 1 through Zone 10. These can be changed to any of the Types listed in Table 3.3.
NOTE: The third character in the SIA-DCS Format (x in the table below) represents the zone number.
Zone Alarm Type
Pull-Station
Waterflow
Waterflow Nonsilenceable
Combo
Combo AutoResettable Supervisory
2-Wire Detector
Normally Open Contact
Fire
Tamper
Supervisory
Supervisory AutoResettable
Medic-Alert
Hazard-Alert
Tornado-Alert
Proc-Mon
Procmon-AR
AC-Loss-Mon
Drill-Switch
Drill-Switch AutoResettable
The following tables list all of the Events and their default Event Codes for the Ademco Contact ID
and SIA-DCS Communication Formats.
NOTE: A detector freeze condition will be reported as a Supervisory Event Code.
94
Ademco Contact ID
Active
115
113
113
113
113
111
110
110
144
200
200
100
150
150
200
200
301
604
604
Table 3.3 Zone Alarm Type Event Codes
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C2 1/24/2012
Master Programming Level
SIA-DCS Format
Active Restoral
FAx FHx
SAx SHx
SAx SHx
SAx SHx
SAx SHx
FAx FHx
UAx UHx
FAx FHx
TAx THx
FSx FVx
FSx FVx
MAx MHx
PAx PHx
PAx PHx
IAx IRx
IAx IRx
ATx ARx
FIx FKx
FIx FKx