Master Programming Level - Honeywell NOTIFIER SFP-10UD Series Manual

Master Programming Level

Entering the Master level password (default 00000) will cause the following screen to appear:
If the Maintenance level password (default 11111) is entered, the following screen will appear:
Note that in the two preceding screens, an arrow appears to inform the programmer that additional
options can be viewed by pressing the keypad down arrow key.
3.5 Master Programming Level
When the Master Program Level password is entered, the control panel will enter user Program-
ming mode. In this mode, the piezo sounder remains off, the trouble relay is activated and the sys-
tem Trouble LED flashes until Programming mode is exited. The following display will appear:
The down arrow which appears in the display indicates that additional programming choices can be
viewed by pressing the down arrow key on the keypad. If a down and up arrow appear in the dis-
play, pressing the 'down' arrow key will display the subsequent Programming Screens as illustrated
below while pressing the 'up' arrow key will display the previous screen.
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C2 1/24/2012
PROGRAMMING
1=INPUT ZONES
2=NACS
3=RELAYS
PROGRAMMING
1=INPUT ZONES
2=HISTORY
3=WALKTEST
PROGRAMMING
1=INPUT ZONES
2=NACS
3=RELAYS
Programming Screen #1
Programming
61