Time-Date - Honeywell FIre-LITe ALArms MS-9600LS Manual

Master Programming Level

Time-Date

SYSTEM SETUP
1=TROUBLE REM
The control panel time and date can be changed by pressing 3 while viewing the System Setup
2=BANNER
Screen #1. The following screen will be displayed:
3=TIME-DATE
System Setup Screen #1

To change the time, press 1 while viewing the Time-Date Screen. The following screen will be dis-
played:
A flashing cursor is located toward the top left of the display. Below the cursor is the current time.
To change the time, enter the two-digit hours followed by the two-digit minutes. The cursor will
move one position to the right each time a digit is entered. After the last minutes digit is entered,
the cursor will again move one position to the right. At this point enter 1 for AM or 2 for PM. The
display will then return to the Time-Date Screen which will show the new time entry. If an error is
made while entering a digit, press the CLR key to delete the entire entry and beginning again.

To change the date, press 2 while viewing the Time-Date Screen. The following screen will be dis-
played:
A flashing cursor is located toward the top left of the display. Below the cursor is the current date.
To change the date, enter the two-digit month followed by the two-digit day and then the two-digit
year (09 for 2009, 10 for 2010, etc.). The cursor will move one position to the right each time a
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
1=TIME
2=DATE
3=CLOCK FORMAT
1=DAYLIGHT SAVINGS
Time
10:00 AM
1=AM
Date
MONTH DAY YEAR
02-04-2010
TIME AND DATE
10:00 AM
02-04-2010
Time-Date Screen #1
TIME AND DATE
Time-Date Screen #2
ENTER TIME
2=PM
Time Screen
ENTER DATE
Date Screen
Programming
12HR
103