Silence; Auto Silence - Honeywell NOTIFIER SFP-10UD Series Manual

Master Programming Level
NAC #

1=SILENCE

YES
2=AUTO SILENCE NO
3=SIL INHIBITED NO
NAC Screen #2
PROGRAM NAC #
1=SILENCEABLE YES

2=AUTO SILENCE

NO
3=SIL INHIBITED NO
NAC Screen #2
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C2 1/24/2012
Silence
Pressing 1 while viewing NAC Screen #2 will cause the following screen to be displayed:
1=SILENCEABLE
2=NON SILENCEABLE
3=SYNC MUTE
Pressing 1 while viewing the Silenceable Screen will program the selected NAC as a silenceable
circuit. This will allow the NAC to be silenced by pressing the Alarm Silence key or by the Auto
Silence feature.
Pressing 2 while viewing the Silenceable Screen will program the selected NAC as a nonsilence-
able circuit. This will prevent the selected main circuit board NAC from being silenced by pressing
the Alarm Silence key or by the Auto Silence feature.
Pressing 3 while viewing the Silenceable Screen will program the selected NAC as a synchronized
mute circuit. Refer to "Synchronized NAC Operation" on page 72 for a description of synchroni-
zation.
Important: When a Notification Appliance Circuit with a mix of audible and visual devices is pro-
grammed for Sync Mute, only the audible devices will be turned off if the Silence key is pressed or if
the Autosilence feature is enabled. The visual devices (strobes, etc.) will continue to operate.
Auto Silence
The Auto Silence feature, when enabled, automatically silences all main circuit board silenceable
notification appliances after a programmed length of time. To enable this feature and program the
time delay before Auto Silence activation, press 2 while viewing NAC Screen #2. The following
screens will be displayed:
1=30 MINUTES
SILENCEABLE
Silenceable Screen
AUTO SILENCE
1=NO
2=5 MINUTES
3=10 MINUTES
Auto Silence Screen #1
AUTO SILENCE
1=15 MINUTES
2=20 MINUTES
3=25 MINUTES
Auto Silence Screen #2
AUTO SILENCE
Auto Silence Screen #3
Programming
73