2: Signal Silence; 3: System Reset - Honeywell Notifier NFS-320/E/C Operation Manual

Control Keys
You can also press this key to display multiple alarms or troubles. If more than one alarm or tr ouble
exists, the control panel displays the next alarm or trouble for 3 seconds (or until you press the
ACKNOWLEDGE
NOTE: If Local Control is set to "1" (NO), the FACP will not respond to
piezo will not sound.
2.3.2 Signal Silence
Use the
SIGNAL SILENCE
connected to Notification Appliance Circuits. When pressed, the control panel does the following:
• Turns off the panel sounder
• Turns off all silenceable output circuits
• Lights the
• Sends a
terminals, and FDU-80 annunciators
Partial Signal Silence
When some active oututs are silenced and others remain constant, the
flash
NOTE: If Local Control is set to "1" (NO) or "2" (Partial Control), the FACP will not respond to
SIGNAL SILENCE
2.3.3 System Reset
Use the
SYSTEM RESET
following:
• Clears ALL active inputs
• Interrupts resettable power
• Sends a "System Reset" message to the History buffer, and installed printers, CRT-2 terminals,
and FDU-80 annunciators
• Decouples from Noti•Fire•Net, if connected, for 60 seconds to allow Cooperative Control By
Event (CCBE) to clear.
If any alarm or trouble exists after you press the
panel audio and visual indicators will reactivate.
NOTE: Trouble conditions will not clear and re-report upon reset.
NOTE: If Local Control is set to "1" (NO), the FACP will not respond to
NFS-320/E/C Operations Manual — P/N 52747:A 12/12/2006
key), then displays the next alarm or trouble.
/
SCROLL DISPLAY
key to silence the panel sounder and turn off all audio and visual devices
LED
SIGNALS SILENCED
message to the History buffer and installed printers, CRT-2
SIGNALS SILENCED
.
key to reset the control panel. When pressed, the control panel does the
ACKNOWLEDGE
SIGNALS SILENCED
key, all NACs, control outputs, and
SYSTEM RESET
SYSTEM RESET
Use of the Controls
, and the
LED will
.
15