Cleaning or installing the filter
Regularly clean or replace the filters in the projector to ensure dust and other foreign materials are
kept out of the projector.
1. Turn off the projector.
2. Remove the filter cover.
3. Remove the filter from its compartment.
4. Clean or replace the filter.
Replace fog filters after each use of the projector to a maximum of 20 hours. The life of the filter is
approximately 20 hours based on environmental conditions. Leave the filters in their sealed
packaging until ready for use.
Do not re-use the fog filters as they clog up with oil and the projector overheats and shuts down.
Inspire Series Installation and Setup Guide
020-001933-01 Rev. 1 (10-2021)
Copyright ©2021 Christie Digital Systems USA Inc. All rights reserved.
Installation and setup
24