Table of Contents
Advertisement
Chapter 2: Controls and Indicators
Table 2-4 Normal Unsaved Initialization Messages
Cabletron
Hardware Init
Cabletron
BOOTP Discovery
Cabletron
TFTP Req. State
Cabletron
TFTP Complete
Cabletron
Programming Flash
Cabletron
Boot Complete
2.3.4 Saved System Messages
Saved System messages are device related startup or boot strap messages,
BOOTP/tftp host, or startup error messages. To access the Saved System
messages queue, perform the following steps:
1. Enter the Saved Alarm messages queue as described in Section 2.3.2.
2. Press the Display button for two seconds and then release to display
the first Saved System message.
3. Press and immediately release the Display button to display each
subsequent message.
If the Display button is not pressed again for ten seconds, the LCD
defaults to the product name.
Page 2-6
Cabletron
Boot From Flash
Cabletron
RARP Req. State
Cabletron
TFTP in Progress
Cabletron
Erasing Flash
Cabletron
Flash Programmed
Cabletron
Test in Progress
MicroMMAC Installation Guide
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the MicroMMAC-24E and is the answer not in the manual?
Questions and answers