Figure 3-5 GBIC Metal Locking Bar Positions
Â
➀
GBIC
➁
Top of GBIC
➂
Metal locking bar (up position, unlocked)
➃
Network port
➄
1G-2GBIC (Ethernet expansion module)
6. Once the GBIC 20-pin connector ➅ has been firmly seated into the port slot, push down on the
GBIC metal locking bar until it clicks into place as shown in View B. Do NOT force the locking
bar into the locked position. If there is significant resistance while attempting to close the
locking bar, remove the GBIC. Inspect it for any problems with the connectors. If there are any
problems, contact Enterasys Networks for technical support (refer to
Section
1.4). If there are no problems, re-insert the GBIC carefully, and firmly seat it in the port
slot connector.
À
Á
È
Installing the Locking Bar GBIC
Æ
Ã
➅
20-pin connector (insertion side)
➆
Alignment slots
➇
Port slot
➈
Metal locking bar (down position, locked)
Hardware Installation
Ä
Ç
Å
"Getting
Help" in
3-11